Nissan Juke Service and Repair Manual : Driveline transfer: TY21B
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Service Notice or Precautions for Transfer
- Preparation
- System description
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/Circuit diagnosis
- P1804, P1809 4WD control module
- P1808 Wheel speed sensor
- P1811 power supply circuit for 4wd control module
- P1813 4WD mode switch
- P181B incomplete selfshut
- P181D engine torque signal
- P181E steering angle sensor
- P181F incomplete calibration
- P1820 engine speed signal
- P1829 accelerator pedal position sensor
- P182D 4WD solenoid left
- P182E 4WD solenoid right
- P182F coupling temperature sensor left
- P1830 ABS operation signal
- P1831 VDC operation signal
- P1832 TCS operation signal
- P183A coupling temperature sensor right
- P183B solenoid power supply
- P183C decel G sensor
- P183D side G sensor
- P183E yaw rate sensor
- P183F gear position signal
- P1840 output speed signal
- P1864 input speed signal
- P1865 gear ratio signal
- U1000 can comm circuit
- U1010 control unit (CAN)
- Power supply and ground circuit
- 4WD warning lamp
- 4WD mode indicator lamp (4WD-V)
- 4WD mode indicator lamp (4WD)
- Symptom diagnosis
- 4WD warning lamp does not turn on
- 4WD warning lamp does not turn off
- Heavy tight-corner braking symptom occurs
- Vehicle does not enter 4WD mode
- 4WD warning lamp blinks quickly
- 4WD warning lamp blinks slowly
- Noise, vibration and harshness (NVH) troubleshooting
- Periodic maintenance
- Removal and installation
- Unit removal and installation
- Unit disassembly and assembly
- Service data and specifications
Clutch Cover
...
Precaution
...
Other materials:
P012B TC boost sensor
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK GROUND CONNECTIONS
1. Turn ignition switch OFF.
2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit
Inspection".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or ...
Fuel tank
Exploded View
1. Fuel tank cap
2. Grommet
3. Fuel filler tube
4. Clamp
5. Fuel filler hose
6. Clamp
7. Vent hose
8. Fuel tank
9. Mounting band (RH)
10. Mounting band (LH)
: N·m (kg-m, ft-lb)
Removal and Installation
WARNING:
Be sure to read “General Precautions” when worki ...
Three Way Catalyst
If a large amount of unburned fuel flows into the catalyst, the catalyst
temperature will be excessively high. To
prevent this, follow the instructions.
• Use unleaded gasoline only. Leaded gasoline will seriously damage the three
way catalyst.
• When checking for ignition spark or meas ...
