Nissan Juke Service and Repair Manual : P183C decel G sensor

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.DTC REPRODUCTION PROCEDURE

1. Start the engine and drive at 30 km/h (19 MPH) or more for approximatelyWith CONSULT-III


1. Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1minute.

2. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Is DTC “P183C” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-71, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS

Perform self-diagnosis for “ABS”.With CONSULT-III


Perform self-diagnosis for “ABS”.

Is any DTCs detected? YES >> Check the DTCs. Refer to BRC-142, "DTC Index".

NO >> GO TO 2.

2.ERASE SELF-DIAGNOSTIC RESULT

1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.With CONSULT-III


1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.

2. Start the engine and drive vehicle at 30 km/h (19 MPH) or more.

3. Check that ABS warning lamp turns OFF.

Does ABS warning lamp turn OFF? YES >> GO TO 3.

NO >> Refer to BRC-212, "Diagnosis Procedure".

3.CHECK TERMINALS AND HARNESS CONNECTORS

Check 4WD control module pin terminals for damage or loose connection with harness connector.

Is inspection result normal? YES >> After turning the ignition switch OFF, perform DTC confirmation procedure again. When DTC “P183C” is detected, Replace 4WD control module. Refer to DLN-91, "Removal and Installation".

NO >> Repair or replace error-detected parts.

    P183B solenoid power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    P183D side G sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    Other materials:

    Basic inspection
    Work Procedure 1.INSPECTION START 1. Check service records for any recent repairs that may indicate a related malfunction, or a current need for scheduled maintenance. 2. Open engine hood and check the following: - Harness connectors for improper connections - Wiring harness for improper con ...

    5TH main gear assembly
    Removal and Installation REMOVAL 1. Shift the shifter lever to the 3rd gear position. 2. Disconnect the shifter cable and the selector cable from shifter lever A and selector lever. Refer to TM-25, "Removal and Installation". CAUTION: Never move shifter lever A and the selector l ...

    B2601 shift position
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2601 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B2601 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, &qu ...