Nissan Juke Service and Repair Manual : P183D side G sensor

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.DTC REPRODUCTION PROCEDURE

1. Start the engine and drive at 30 km/h (19 MPH) or more for approximatelyWith CONSULT-III


1. Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1minute.

2. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Is DTC “P183D” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-70, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS

Perform self-diagnosis for “ABS”.With CONSULT-III


Perform self-diagnosis for “ABS”.

Is any DTCs detected? YES >> Check the DTCs. Refer to BRC-142, "DTC Index".

NO >> GO TO 2.

2.ERASE SELF-DIAGNOSTIC RESULT

1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.With CONSULT-III


1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.

2. Start the engine and drive vehicle at 30 km/h (19 MPH) or more.

3. Check that ABS warning lamp turns OFF.

Does ABS warning lamp turn OFF? YES >> GO TO 3.

NO >> Refer to BRC-212, "Diagnosis Procedure".

3.CHECK TERMINALS AND HARNESS CONNECTORS

Check 4WD control module pin terminals for damage or loose connection with harness connector.

Is inspection result normal? YES >> After turning the ignition switch OFF, perform DTC confirmation procedure again. When DTC “P183D” is detected, Replace 4WD control module. Refer to DLN-91, "Removal and Installation".

NO >> Repair or replace error-detected parts.

    P183C decel G sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    P183E yaw rate sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    Other materials:

    Precautions for Drive Shaft
    • Observe the following precautions when disassembling and assembling drive shaft. - Never disassemble joint sub-assembly because it is non-overhaul parts. - Perform work in a location which is as dust-free as possible. - Clean the parts, before disassembling and assembling. - Prevent the en ...

    Except for M/T models
    Except for M/T models : Description ECM receives a G sensor signal from TCM via CAN communication to switch combustion for the direct injection gasoline system. For the direct injection gasoline system, refer toEC-48, "DIRECT INJECTION GASOLINE SYSTEM : System Description". Except ...

    P0712 transmission fluid temperature sensor A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION ...