Writing unit parameter

Description Perform writing unit parameter of electric controlled coupling after replacing 4WD control module, rear final drive assembly or electric controlled coupling. Refer to DLN-39, "Wor ...

P1804, P1809 4WD control module

DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

Other materials:

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

Moving Object Detection (MOD)
CAMERA button (conveniently mounted on the physical display bezel assembly to activate or toggle camera modes) WARNING Failure to strictly follow the safety warnings and operational instructions for the correct use of the Moving Object Detection (MOD) ...

P0730 incorrect gear ratio
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, perform the following procedure to confirm the ...