Nissan Juke Service and Repair Manual : P181F incomplete calibration

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.DTC REPRODUCTION PROCEDURE

1. Turn the ignition switch OFF to ON.With CONSULT-III


1. Turn the ignition switch OFF to ON.

2. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Is DTC “P181F” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-51, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM WRITING UNIT PARAMETER

1. Erase self-diagnostic result for “ALL MODE AWD/4WD”.

2. Perform writing unit parameter. Refer to DLN-39, "Work Procedure".

3. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Is any DTC except “P181F” detected? YES >> Check DTC.

NO >> GO TO 2.

2.PERFORM SELF-DIAGNOSIS

1. Erase self-diagnostic result for “ALL MODE AWD/4WD”.With CONSULT-III


1. Erase self-diagnostic result for “ALL MODE AWD/4WD”.

2. Turn the ignition switch OFF, and then wait 10 seconds or more.

3. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Is DTC “P181F” detected? YES >> Replace 4WD control module. Refer to DLN-91, "Removal and Installation".

NO >> Check 4WD control module pin terminals for damage or loose connection with harness connector.

If any items are damaged, repair or replace the error-detected parts.

    P181E steering angle sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    P1820 engine speed signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    Other materials:

    No or very little acceleration, increase in engine speed
    Description CHART 8: NO OR VERY LITTLE ACCELERATION, INCREASE IN ENGINE SPEED Diagnosis Procedure 1.CHECK FUEL Check that the fuel reservoir is correctly filled and with the right fuel. >> GO TO 2. 2.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit ...

    Power supply and ground circuit
    Diagnosis Procedure 1.CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible links are not blown. Is the fuse fusing? YES >> Replace the blown fuse or fusible link after repairing the affected circuit if a fuse or fusible link is blown. NO >> GO TO 2. ...

    ABS branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the ABS actuator and electric unit (control unit) for damage, bend and loose connection (unit side and connector side). ...