Nissan Juke Service and Repair Manual : Vehicle does not enter 4WD mode

Description

Vehicle does not enter 4-wheel drive mode even though 4WD warning lamp turned to OFF.

Diagnosis Procedure

1.CHECK 4WD WARNING LAMP

Turn the ignition switch ON.

Does 4WD warning lamp turn ON? YES >> GO TO 2.

NO >> Proceed to diagnosis procedure. Refer to DLN-80, "Diagnosis Procedure".

2.CHECK PARKING BRAKE SWITCH SIGNAL

Check “PKB SW� of CONSULT-III “DATA MONITOR� for “ALL MODE AWD/4WD�.With CONSULT-III


Check “PKB SW� of CONSULT-III “DATA MONITOR� for “ALL MODE AWD/4WD�.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3.

NO >> Proceed to diagnosis procedure. Refer to BRC-208, "Diagnosis Procedure".

3.CRUISE TEST

Drive the vehicle for a period of time.

Does any symptom occur? YES >> Replace electric controlled coupling for mechanical malfunction (mechanical engagement of clutch is not possible). Refer to DLN-139, "Removal and Installation".

NO >> Check each harness connector pin terminal for disconnection.

    Heavy tight-corner braking symptom occurs
    Description Heavy tight-corner braking symptom occurs when the vehicle is driven and the steering wheel is turned fully to either side after the engine is started. NOTE: Light tight-corner bra ...

    4WD warning lamp blinks quickly
    Description While driving, 4WD warning lamp blinks 2 times in 1 second and it turns OFF after 1 minute. NOTE: • This symptom protects drivetrain parts when a heavy load is applied to the el ...

    Other materials:

    Service data and specifications (SDS)
    Wheel Bearing Drive Shaft 2WD *: For measuring position, refer to FAX-26, "WHEEL SIDE : Disassembly and Assembly" (Wheel side), FAX- 29, "TRANSAXLE SIDE : Disassembly and Assembly" (Transaxle side). 4WD *: For measuring position, refer to FAX-26, "WHEEL SIDE : ...

    Can communication
    CAN COMMUNICATION : System Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped ...

    IGN off interlock door unlock function does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT� SETTING IN “WORK SUPPORT� 1. Select “DOOR LOCK� of “BCM� using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT� in “WORK SUPPORT� mode. 3. Check “AUTOMATIC LOCK/UNLOCK SELECT� in “WORK SUPPORT�. Re ...