Nissan Juke Service and Repair Manual : Symptom diagnosis
- 4WD warning lamp does not turn on
- 4WD warning lamp does not turn off
- Heavy tight-corner braking symptom occurs
- Vehicle does not enter 4WD mode
- 4WD warning lamp blinks quickly
- 4WD warning lamp blinks slowly
- Noise, vibration and harshness (NVH) troubleshooting
4WD mode indicator lamp (4WD)
Component Function Check
1.4WD MODE INDICATOR LAMP OPERATION CHECK
Check that 4WD mode indicator lamp (4WD) turns on for approximately 1 second
after the ignition switch is
turned ON.
Is the i ...
4WD warning lamp does not turn on
Description
4WD warning lamp does not turn ON when the ignition switch is turned to ON.
Diagnosis Procedure
1.CHECK 4WD WARNING LAMP
Perform the trouble diagnosis for 4WD warning lamp. Refer to DL ...
Other materials:
Precautions for Drive Shaft
• Observe the following precautions when disassembling and assembling drive
shaft.
- Never disassemble joint sub-assembly because it is non-overhaul parts.
- Perform work in a location which is as dust-free as possible.
- Clean the parts, before disassembling and assembling.
- Prevent the en ...
Air breather hose
Removal and Installation
REMOVAL
1. Remove clip from bracket.
2. Remove air breather hose from transaxle assembly.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
• Check that air breather hose is not collapsed or blocked due to folding or
bendin ...
P2127, P2128 APP sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
