Nissan Juke Owners Manual : Operating tips

• When the shift lever is shifted to the R (Reverse) position, the monitor screen automatically changes to the RearView Monitor mode. However, the radio can be heard.

• When the view is switched, the display images on the screen may be displayed with some delay.

• When the temperature is extremely high or low, the screen may not clearly display objects. This is not a malfunction.

• When strong light is directly coming on the camera, objects may not be displayed clearly. This is not a malfunction.

• Vertical lines may be seen in objects on the screen. This is due to strong reflected light from the bumper. This is not a malfunction.

• The screen may flicker under fluorescent light. This is not a malfunction.

• The colors of objects on the RearView Monitor may differ somewhat from the actual color of objects. This is not a malfunction.

• Objects on the monitor may not be clear in a dark environment. This is not a malfunction.

• If dirt, rain or snow accumulates on the camera, the RearView Monitor may not display objects clearly. Clean the camera.

• Do not use alcohol, benzine or thinner to clean the camera. This will cause discoloration.

To clean the camera, wipe with a cloth dampened with diluted mild cleaning agent and then wipe with a dry cloth.

• Do not damage the camera as the monitor screen may be adversely affected.

• Do not use wax on the camera window.

Wipe off any wax with a clean cloth dampened with mild detergent diluted with water.

    Difference between predictive and actual distances
    Backing up on a steep uphill When backing up the vehicle up a hill, the distance guide lines and the vehicle width guide lines are shown closer than the actual distance. For example, the display ...

    Other materials:

    Symptom diagnosis
    COMBINATION SWITCH SYSTEM SYMPTOMS Symptom Table 1. Perform “Data Monitor” of CONSULT-III to check for any malfunctioning item. 2. Check the malfunction combinations. 3. Identify the malfunctioning part from the agreed combination and repair or replace the part. ...

    Door lock actuator
    Driver side DRIVER SIDE : Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >& ...

    Off position warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index&qu ...