Operating tips

• When the shift lever is shifted to the R (Reverse) position, the monitor screen automatically changes to the RearView Monitor mode. However, the radio can be heard. • When the view is switched, t ...

Center ventilators

Adjust the air flow direction of ventilators as illustrated. Adjust the air flow direction of the ventilators by moving the center knob (up/down and left/right) until the preferred position is ac ...

Other materials:

P1612 chain of ECM-IMMU
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P1612 is displayed with DTC U1000 (for BCM), first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC P1612 is displayed with DTC U1010 (for BCM), first perform the trouble diagnosis for DTC U1010. ...

Install
1. Align the head restraint/headrest stalks with the holes in the seat. Make sure that the head restraint/headrest is facing the correct direction. The stalk with the adjustment notch1 must be installed in the hole with the lock knob2 . 2. Push and hold the lock knob and push the head restrai ...

Symptom diagnosis
Noise, vibration and harshness (NVH) Troubleshooting NVH troubleshooting Chart 1. Locate the area where noise occurs. 2. Confirm the type of noise. 3. Specify the operating condition of engine. 4. Check specified noise source. If necessary, repair or replace these parts. A: Closely rel ...