Nissan Juke Service and Repair Manual : General Specification

CAUTION:


CAUTION:
• Use only Genuine NISSAN CVT Fluid NS-2. Never mix with other fluid.

• Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in driveability and CVT durability, and may damage the CVT, which is not covered by the warranty.

*1: Refer to MA-13, "Fluids and Lubricants".

*2: The fluid capacity is the reference value. Check the fluid level with CVT fluid level gauge.

    Shift Characteristics
    Numerical value data are reference values CAUTION: Lock-up clutch is engaged when vehicle speed is approximately 18 km/h (11 MPH) to 90 km/h (56 MPH). ...

    Other materials:

    Performance test
    Inspection INSPECTION PROCEDURE 1. Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge. 2. Start the engine, and set to the following condition. Test condition 3. Maintain test condition until A/C system becomes stable. (Approximately 10 minutes) 4. Check t ...

    C1140 actuator relay system
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CON ...

    S mode indicator
    Component Function Check 1.CHECK S MODE INDICATOR FUNCTION Check S mode indicator turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection results normal? YES >> INSPECTION END NO >> Go to TM-469, "Diagnosis Procedure". Diagnosis Procedure 1.CH ...