Unit disassembly and assembly

Torque converter and converter housing oil seal Exploded View 1. Transaxle assembly 2. Converter housing oil seal 3. Torque converter : Always replace after every disassembly. : Apply CVT ...

General Specification

CAUTION: • Use only Genuine NISSAN CVT Fluid NS-2. Never mix with other fluid. • Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in driveability and CVT durability, ...

Other materials:

P1551, P1552 battery current sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. ...

Front wheel hub and K
Exploded View 1. Steering knuckle 2. Splash guard 3. Hub bolt 4. Wheel hub assembly (Bearing-integrated type) 5. Disc rotor 6. Wheel hub lock nut 7. Adjusting cap 8. Cotter pin A. Tightening must be done following the installation procedure. Refer to FAX-68, "Removal and Insta ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...