Nissan Juke Service and Repair Manual : The braking distance is long

Description

Brake stopping distance is long when ABS function is operated.

Diagnosis Procedure

CAUTION:
Brake stopping distance on slippery road like rough road, gravel road or snowy road may become longer when ABS is operated than when ABS is not operated.

1.CHECK BRAKING FORCE

Check brake force using a brake tester.

Is the inspection result normal? YES >> GO TO 2.

NO >> Check each components of brake system.

2.CHECK BRAKE PERFORMANCE

Disconnect ABS actuator and electric unit (control unit) connector so that ABS does not operate. Check brake stopping distance in this condition. Connect harness connectors after checking.

Is the inspection result normal? YES >> Normal

NO >> Check each components of brake system

    Unexpected brake pedal reaction
    Description A malfunction of brake pedal feel (height or others) is detected when brake pedal is depressed. Diagnosis Procedure 1.CHECK FRONT AND REAR AXLE Check that there is no excessive loose ...

    Does not operate
    Description ESP function, TCS function, ABS function, EBD function and brake limited slip differential (BLSD) function does not operate. Diagnosis Procedure CAUTION: • ESP function, TCS funct ...

    Other materials:

    Doors
    WARNING •  Always have the doors locked while driving. Along with the use of seat belts, this provides greater safety in the event of an accident by helping to prevent persons from being thrown from the vehicle. This also helps keep children and others from unintentionally opening the ...

    P0200 fuel injector
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK FUEL INJECTOR POWER SUPPLY CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect ECM harness connector. 3. Disconnect fuel injector harness connector. 4. Check the continuity between fuel injector harness connector an ...

    B1065, B1070 passenger air bag module
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...