Nissan Juke Service and Repair Manual : Brake Control System with ESP
- How to use this manual
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Precaution for Procedure without Cowl Top Cover
- Precaution for Brake System
- Precaution for Brake Control system
- Precaution for Harness Repair
- System description
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- Diagnosis and repair work flow
- Additional service when replacing ABS actuator and electric unit (control unit)
- Adjustment of steering angle sensor neutral position
- DTC/circuit diagnosis
- C1101, C1102, C1103, C1104 wheel sensor
- C1105, C1106, C1107, C1108 wheel sensor
- C1109 power and ground system
- C1110, C1170 ABS actuator and electric unit (control unit)
- C1111 ABS motor, motor relay system
- C1113, C1145, C1146 yaw rate/side/decel g sensor
- C1115 wheel sensor
- C1116 stop lamp switch
- C1120, C1122, C1124, C1126 ABS in valve system
- C1121, C1123, C1125, C1127 ABS out valve system
- C1130 engine signal
- C1140 actuator relay system
- C1142 press sensor
- C1143 steering angle sensor
- C1144 incomplete steering angle sensor adjustment
- C1155 brake fluid level switch
- C1164, C1165 CV system
- C1166, C1167 SV system
- C1176 stop lamp SW2
- U1000 can comm circuit
- U1010 control unit (can)
- Power supply and ground circuit
- Parking brake switch
- ESP off switch
- ABS warning lamp
- Brake warning lamp
- ESP warning lamp
- ESP off indicator lamp
- Symptom diagnosis
- Excessive operation frequency
- Unexpected brake pedal reaction
- The braking distance is long
- Does not operate
- Brake pedal vibration or operation sound occurs
- Vehicle jerks during
- Normal operating condition
- Removal and installation
ABS actuator and electric unit (control unit)
Exploded View
LHD
1. ABS actuator and electric unit (control
unit)
2. ABS actuator and electric unit (control
unit) harness connector
3. Bracket
A. To master cylinder secondary side
B. To m ...
How to use this manual
Information
Both “VDC” and “ESP” are used in this manual. These indicate the same system. ...
Other materials:
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication system for real time
application. It is an on-vehicle
multiplex communication system with high data communication speed and excellent
error detection ability.
Many electronic control units are equipped onto vehicles, and ea ...
Precaution Necessary for Steering Wheel Rotation after Battery Dis
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. Information necessary to service the system safely is
include ...
