Nissan Juke Service and Repair Manual : Removal and installation
- Wheel sensor
- Sensor rotor
- ABS actuator and electric unit (control unit)
- Yaw rate/side/decel G sensor
- Steering angle sensor
- ESP off switch
Normal operating condition
Description
...
Wheel sensor
Front wheel sensor : Exploded View
1. Front LH wheel sensor
2. Front LH wheel sensor harness connector
: Vehicle front
: N·m (kg-m, in-lb)
NOTE:
Front RH wheel sensor is symmetrically opposit ...
Other materials:
Filament
Inspection and Repair
INSPECTION
1. When measuring voltage, wrap tin foil around the top of the negative
probe. Then press the foil against the wire with your finger.
2. Attach probe circuit tester (in Volt range) to middle portion of
each filament.
3. If a filament is burned out, circuit ...
Malfunction indicator lamp
Component Function Check
1.CHECK MIL FUNCTION
1. Turn ignition switch ON.
2. Check that MIL lights up.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Proceed to EC-436, "Diagnosis Procedure".
Diagnosis Procedure INFOID:0000000006547250
1.CHECK DTC
Che ...
C1176 stop lamp SW2
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...
