Nissan Juke Service and Repair Manual : ESP off switch

Removal and Installation

REMOVAL

1. Remove lower instrument panel. Refer to IP-13, "Removal and Installation".

2. Remove ESP OFF switch.

INSTALLATION

Installation is the reverse order of removal.

    Steering angle sensor
    Removal and Installation REMOVAL 1. Remove spiral cable assembly. Refer to SR-16, "Removal and Installation". 2. Remove steering angle sensor. INSTALLATION Note the following, and i ...

    Other materials:

    Thermostat
    Exploded View 1. Thermostat housing 2. Gasket 3. Rubber ring 4. Thermostat 5. Water inlet 6. Clamp 7. Radiator hose (upper) A. To radiator Engine front : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVAL 1. Drain engine coolant from ...

    U0155 lost communication (IPC)
    Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability. Many electronic control units are equipped onto a vehicle, and ...

    P0848 transmission fluid pressure SEN/SW B
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, the ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION With ...