Nissan Juke Service and Repair Manual : Steering System

ESP off switch
Removal and Installation REMOVAL 1. Remove lower instrument panel. Refer to IP-13, "Removal and Installation". 2. Remove ESP OFF switch. INSTALLATION Installation is the reverse ord ...

Other materials:

P1804, P1809 4WD control module
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

Additional service when replacing transaxle assembly
Description Perform the following work after the transaxle assembly is replaced. CHECK LOADING OF CALIBRATION DATA • The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the ROM assembly (in the control valve). This enables the TCM to perform ...

P0132 A/F sensor 1
DTC Logic DTC DETECTION LOGIC To judge the malfunction, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal is not inordinately high. DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform ...