Nissan Juke Service and Repair Manual : Service data and specifications (SDS)

General Specifications

Steering Wheel Axial End Play and Play


Steering Wheel Axial End Play and Play

Steering Wheel Turning Force


Steering Wheel Turning Force

Steering Angle


Steering Angle

Steering Column Operating Range


Steering Column Operating Range

*: For measuring position, refer to ST-11, "Inspection".


*: For measuring position, refer to ST-11, "Inspection".

Rack Stroke

Socket Swing Force


Socket Swing Force

*: For measuring position, refer to ST-21, "Inspection".


*: For measuring position, refer to ST-21, "Inspection".

Socket Axial End Play

Inner Socket Length


Inner Socket Length

Steering Control System


    Steering gear and linkage
    Exploded View REMOVAL LHD Models 1. Steering gear assembly 2. Heat insulator 3. Front suspension member : Vehicle front : Always replace after every disassembly. : N·m (kg-m, ft-lb) : N ...

    Other materials:

    P0444 EVAP canister purge volume control solenoid valve
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ...

    Key switch
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “KEY ON SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Key switch is OK. N ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...