Nissan Juke Service and Repair Manual : P2118 throttle control motor

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.

2. Turn ignition switch ON.

3. Turn ignition switch OFF and wait at least 10 seconds.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON and wait at least 2 seconds.

2. Start engine and let it idle for 5 seconds.

3. Check DTC.

Is DTC detected? YES >> Proceed to EC-381, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK THROTTLE CONTROL MOTOR OUTPUT SIGNAL CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect electric throttle control actuator harness connector.

3. Disconnect ECM harness connector.

4. Check the continuity between electric throttle control actuator harness connector and ECM harness connector.

5. Also check harness for short to ground and to power.


5. Also check harness for short to ground and to power.

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace error-detected parts.

2.CHECK THROTTLE CONTROL MOTOR

Check the throttle control motor. Refer to EC-382, "Component Inspection".

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> Replace electric throttle control actuator. Refer to EM-28, "Exploded View".

Component Inspection

1.CHECK THROTTLE CONTROL MOTOR

1. Turn ignition switch OFF.

2. Disconnect electric throttle control actuator harness connector.

3. Check the resistance between electric throttle control actuator terminals as per the following.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> Replace electric throttle control actuator. Refer to EM-28, "Exploded View".

    P2101 electric throttle control function
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P2101 is displayed with DTC P2100, first perform the trouble diagnosis for DTC P2100. Refer to EC-376, "DTC Logic". • If DTC P2101 is ...

    P2119 electric throttle control actuator
    DTC Logic DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. ...

    Other materials:

    Inspection
    LEVEL • Check that the reservoir tank engine coolant level is within the “MIN” to “MAX” when the engine is cool. A : MAX B : MIN • Adjust the engine coolant level if necessary. LEAKAGE • To check for leakage, apply pressure to the cooling system with the radiator cap tester ( ...

    Intelligent Cruise Control (ICC) (for vehicles with ProPILOT Assist)
    WARNING Failure to strictly adhere to these warnings and operational instructions regarding the Intelligent Cruise Control (ICC) system in your Nissan Leaf could result in a serious accident, personal injury, or death. The ICC system is strictly a driver-assistance aid; it is not ...

    Hazard reminder operation does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-141, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index&q ...