Nissan Juke Service and Repair Manual : P173A 2GR incorrect ratio

DTC Logic

DTC DETECTION LOGIC

DTC COFIRMATION PROCEDURE


DTC COFIRMATION PROCEDURE

CAUTION:
• Be sure to perform "TM-444, "Diagnosis Procedure"" and then perform "DTC CONFIRMATION PROCEDURE".

• Never perform "TC CONFIRMATION PROCEDURE" before the repairs. Doing so may result in a secondary malfunction.

• Be careful of the driving speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

1. Start the engine.

2. Drive the vehicle.

3. Maintain the following conditions for 10 seconds or more.

Selector lever : “D” position Accelerator pedal position : 0.7/8 or more Vehicle speed : 45 km/h (28 MPH) or more

4. Stop the vehicle
5. Check the first trip DTC.

Is “P173A” detected? YES >> Go to TM-444, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace the transaxle assembly. Refer to TM-508, "Removal and Installation".

NO >> Repair or replace the malfunctioning parts.

    P1739 1GR incorrect ratio
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: • Be sure to perform “TM-442, "Diagnosis Procedure"” and then perform “DTC CONFIRMATION PROCEDURE”. • N ...

    P173B 1GR incorrect ratio
    DTC Logic DTC CONFIRMATION PROCEDURE CAUTION: • Be sure to perform “TM-445, "Diagnosis Procedure"” and then perform “DTC CONFIRMATION PROCEDURE”. • Never perform "DTC ...

    Other materials:

    SRS air bag warning lamp does not turn off
    Diagnosis Procedure 1.CHECK AIR BAG MODULE AND SEAT BELT PRE-TENSIONER Check the deployment of air bag module. Is air bag module deployed? YES >> Replace the malfunctioning parts. NO >> GO TO 2. 2.CHECK AIR BAG FUSE Check 10 A fuse [No.2, located in fuse block (J/B)]. Is ...

    Thermo control amplifier
    Component Function Check 1.CHECK A/C ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 3. Select “THERMO AMP” in “DATA MONITOR” mode, and check status under the following condition. Is the inspection result normal ...

    Charging timer
    Optimize your energy management and utility costs by utilizing the charging timer feature of the Nissan Leaf. This function allows you to create custom schedules for your vehicle's Li-ion battery charging cycles. Once you have established your preferred schedule, the Nissan Leaf will automatically c ...