Nissan Juke Service and Repair Manual : DTC/CIRCUIT DIAGNOSIS
- U0073 communication bus A off
- U0100 lost communication (ECM A)
- U0140 lost communication (BCM)
- U0141 lost communication (BCM A)
- U0155 lost communication (IPC)
- U0300 can communication data
- U1000 can comm circuit
- U1117 lost communication (ABS)
- U1119 lost comm (multi-display)
- P062f eeprom
- P0705 transmission range switch A
- P0706 transmission range sensor A
- P0711 transmission fluid temperature sensor A
- P0712 transmission fluid temperature sensor A
- P0713 transmission fluid temperature sensor A
- P0715 input speed sensor A
- P0720 output speed sensor
- P0740 torque converter
- P0743 torque converter
- P0744 torque converter
- P0746 pressure control solenoid A
- P0846 transmission fluid pressure SEN/SW B
- P0847 transmission fluid pressure SEN/SW B
- P0848 transmission fluid pressure SEN/SW B
- P0863 TCM communication
- P0962 pressure control solenoid A
- P0963 pressure control solenoid A
- P1586 G sensor
- P1588 G sensor
- P1701 TCM
- P1739 1GR incorrect ratio
- P173A 2GR incorrect ratio
- P173B 1GR incorrect ratio
- P173C 2GR incorrect ratio
- P17B4 low brake solenoid
- P17B5 low brake solenoid
- Component Inspection (Low Brake Solenoid Valve)
- P17B7 high clutch solenoid
- P17B8 high clutch solenoid
- P17Ba primary pressure solenoid
- P17BB primary pressure solenoid
- P2765 clutch B speed sensor
- Main power supply and ground circuit
- S mode switch
- S mode indicator
- Shift position indicator circuit
- Shift lock system
CVT position
Inspection and Adjustment
INSPECTION
1. Turn ON the ignition switch with the selector lever at the P position.
2. Press the selector button with the brake pedal depressed, and confirm that
the le ...
U0073 communication bus A off
Description
CAN (Controller Area Network) is a serial communication line for real-time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellen ...
Other materials:
P0335 CKP sensor (POS)
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
ignition switch OFF and wait at
least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following proced ...
Continuously Variable Transmission (CVT)
The Continuously Variable Transmission (CVT) in your vehicle is electronically
controlled to produce maximum power and smooth operation.
The recommended operating procedures for this transmission are shown on the following
pages.
Follow these procedures for maximum vehicle performance and driv ...
U1010 control unit (CAN)
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Many electronic
control units are equipped onto a vehicle, and each co ...
