Nissan Juke Service and Repair Manual : S mode indicator

Component Function Check

1.CHECK S MODE INDICATOR FUNCTION

Check S mode indicator turns ON for approx. 2 seconds when ignition switch turns ON.

Is the inspection results normal? YES >> INSPECTION END

NO >> Go to TM-469, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC (TCM)

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

2. Check “Self Diagnostic Results” in “TRANSMISSION”.

Is any DTC detected? YES >> Check DTC detected item. Refer to TM-366, "DTC Index".

NO >> GO TO 2.

2.CHECK DTC (COMBINATION METER)

Check “Self Diagnostic Results” in “METER/M&A”.With CONSULT-III


Check “Self Diagnostic Results” in “METER/M&A”.

Is any DTC detected? YES >> Check DTC detected item. Refer to MWI-36, "DTC Index".

NO >> GO TO 3.

3.CHECK COMBINATION METER INPUT SIGNAL

1. Shift the selector lever to “D” position.With CONSULT-III


1. Shift the selector lever to “D” position.

2. Select “Data Monitor” in “METER/M&A”.

3. Select “O/D OFF IND”.

4. Check that “O/D OFF IND” turns ON/OFF when S mode switch is operated. Refer to MWI-28, "Reference Value".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".

NO >> GO TO 4.

4.CHECK TCM INPUT/OUTPUT SIGNAL

1. Select “Data Monitor” in “TRANSMISSION”.With CONSULT-III


1. Select “Data Monitor” in “TRANSMISSION”.

2. Select “SPORT MODE SW”.

3. Check that “SPORT MODE SW” turns ON/OFF when S mode switch is operated. Refer to TM-354, "Reference Value".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".

NO >> Check S mode switch circuit. Refer to TM-466, "Diagnosis Procedure".

    S mode switch
    Component Function Check 1.CHECK S MODE INDICATOR FUNCTION Check S mode indicator turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection results normal? YES >> G ...

    Shift position indicator circuit
    Component Parts Function Inspection 1.CHECK SHIFT POSITION INDICATOR 1. Start the engine. 2. Shift selector lever. 3. Check that the selector lever position and the shift position indicator on t ...

    Other materials:

    Cup holders
    Front CAUTION Avoid abrupt starting, sharp cornering, and sudden braking when the central cup holder is being used to prevent spilling your beverages. If the container holds hot liquid, accidental spills can severely scald you or your passenger. ...

    Brake pedal
    Exploded View WITHOUT ESP 1. Clevis pin 2. Brake pedal assembly 3. Brake pedal pad 4. Stop lamp switch 5. Clip 6. Snap pin : Apply multi-purpose grease. : N·m (kg-m, ft-lb) WITH ESP 1. Clevis pin 2. Brake pedal assembly 3. Brake pedal pad 4. Brake switch/brake pedal position ...

    Oil pan (lower)
    Exploded View With Oil Cooler 1. Rear oil seal 2. O-ring 3. Oil pan (upper) 4. Oil pump chain tensioner (for oil pump drive chain) 5. Oil pump drive chain 6. Crankshaft sprocket 7. Oil pump sprocket 8. Oil pump 9. O-ring 10. O-ring 11. Oil pan (lower) 12. Oil pan drain plug ...