Nissan Juke Owners Manual : Integrated control system (if so equipped)
The Integrated Control System is located below the audio system or navigation system (if so equipped). Two Integrated Control System modes can be selected: Drive mode and Climate Control mode.
Depending on which Integrated Control System mode is selected (Drive mode or Climate Control mode), the screen display and some button functions will change.
• Drive mode
In the Drive mode, three types of driving modes can be selected: NORMAL, SPORT and
ECO. See “Drive mode” . In addition, while in the Drive mode, SETUP, Drive information
and ECO information can be displayed and adjusted. See “Drive mode” .
• Climate Control mode
In the Climate Control mode, the climate control can be set and adjusted. See “Automatic
air conditioner (with Integrated Control System)” .
Audible reminders
Key reminder chime
Models with Intelligent Key system:
A chime will sound if the driver side door is opened while the ignition switch
is pushed to the ACC position.
Make sure the ignition switch ...
Drive mode
When the Drive mode select button is pressed, the display and buttons appear
as shown.
1. Drive mode select button
2. SETUP button
3. Drive mode NORMAL button
4. Drive mode SPORT button
5. Dr ...
Other materials:
Additional service when removing battery negative terminal
Description
• The NAVI control unit is equipped with the anti-theft system.
• The NAVI control unit operates after authenticating a fixed four-digit
anti-theft code.
• After removing the battery of the NAVI control unit, the authentication of the
anti-theft code is required.
Work Procedure
...
Additional service when removing battery negative terminal
Description
When the battery negative terminal is disconnected, the initialization is
necessary for normal operation of
power window system.
CAUTION:
The following specified operations can not be performed under the
non-initialized condition.
• Auto-up operation
• Anti-pinch function
Wo ...
Removal and installation
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove power window main switch finisher. Refer to INT-13, "Removal and
Installation".
2. Remove power window main switch (1) from power window
main switch finisher (2) using flat-head screw driver (A).
: Pawl
CAUTION:
...
