Nissan Juke Owners Manual : Instruments and controls
- Cockpit
- Instrument panel
- Meters and gauges
- Speedometer and odometer
- Tachometer
- Engine coolant temperature gauge
- Fuel gauge
- Vehicle information display
- Outside air temperature
- Continuously Variable Transmission (CVT) position indicator (if so equipped)
- Trip computer
- Warning/indicator lights and audible reminders
- Integrated control system (if so equipped)
- Security systems
- Windshield wiper and washer switch
- Rear window wiper and washer switch
- Rear window and outside mirror defroster switch
- Headlight and turn signal switch
- Horn
- Vehicle Dynamic Control (VDC) off switch
- Heated seats (if so equipped)
- Clock (if so equipped)
- Power outlet
- Storage
- Windows
- Moonroof (if so equipped)
- Interior lights
Repair and replacement procedure
The front air bags, side air bags, curtain air bags and pretensioners are designed
to activate on a one-time-only basis. As a reminder, unless it is damaged, the supplemental
air bag warning light ...
Cockpit
1. Outside mirror remote control switch
2. Headlight, fog light and turn signal switch
— Headlight
— Turn signal light
— Fog light
3. Steering wheel
— Electric power steering system
— Horn
— ...
Other materials:
A/C on signal
Component Function Check
1.CHECK A/C ON SIGNAL
With CONSULT-III
1. Turn ignition switch ON.
2. Operate blower motor.
3. Select “AIR CONDITIONER” of “BCM” using CONSULT-III.
4. Select “AIR COND SW” in “DATA MONITOR” mode.
5. Check A/C ON signal when the A/C switch is operated.
Is the inspec ...
B2626 OUTSIDE ANTENNA
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Disconnect outside key antenna (driver side) connector.
2. Perform “INTELLIGENT KEY” Self Diagnostic Result.
Is outside key antenna DTC detected?
YES >> Refer to DLK-236, "Diagnosis ...
B1083 seat belt Pre-tensioner RH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
