Nissan Juke Owners Manual : Tachometer

The tachometer indicates engine speed in revolutions per minute (RPM). Do not


The tachometer indicates engine speed in revolutions per minute (RPM). Do not rev the engine into the red zone1 .

CAUTION

When engine speed approaches the red zone, shift to a higher gear or reduce engine speed. Operating the engine in the red zone may cause serious engine damage.

    Speedometer and odometer
    Speedometer The speedometer indicates vehicle speed in miles per hour (MPH) and kilometers per hour (km/h). Odometer/twin trip odometer The odometer 1 /twin trip odometer 2 are displayed when ...

    Engine coolant temperature gauge
    The gauge 1 indicates the engine coolant temperature. The engine coolant temperature is within the normal range when the gauge is within the zone 2 shown in the illustration. The engine coolant te ...

    Other materials:

    Door lock and unlock switch
    Driver side DRIVER SIDE : Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “CDL LOCK SW”, “CDL UNLOCK SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection resul ...

    P0520 EOP sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

    P0715 input speed sensor A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, p ...