Nissan Juke Owners Manual : Speedometer and odometer
Speedometer
The speedometer indicates vehicle speed in miles per hour (MPH) and kilometers per hour (km/h).
Odometer/twin trip odometer
The odometer 1 /twin trip odometer 2 are displayed when the ignition switch is in the ON position.
The odometer records the total distance the vehicle has been driven.
The twin trip odometer records the distance of individual trips.
Changing the display:
Pushing the reset switch 3 located on the meter panel changes the display as follows: TRIP A → TRIP B → Trip computer mode ?→ TRIP A For trip computer information, see “Trip computer” .
Resetting the trip odometer:
Pushing the reset switch3 for approximately 1 second resets the trip odometer to zero.
Loose fuel cap warning message
Push the reset switch A for more than 1 second to reset the LOOSE FUEL CAP warning message after the fuel cap has been tightened.
For additional information see “Fuel-filler cap” of this manual.
Check tire pressure warning message
The CHECK TIRE PRES (pressure) warning message is displayed when the low tire
pressure warning light is illuminated and low tire pressure
is detected. Check and adjust the tire
pressure to the recommended COLD tire pressure shown on the Tire and Loading Information
label. The CHECK TIRE PRES warning message turns off when the low tire pressure
warning light 
turns off.
The low tire pressure warning light
remains illuminated until the tires
are inflated to the recommended COLD tire pressure. The CHECK TIRE PRES warning
message is displayed each time the ignition switch is placed in the ON position
as long as the low tire pressure warning light
remains illuminated.
For more information see “Low tire pressure warning light” , “Tire Pressure Monitoring System (TPMS)” , and “Wheels and tires” .
Extended storage fuse warning message The SHIPPING MODE ON/PUSH STORAGE FUSE warning message may be displayed if the extended storage fuse switch is not pushed in (switched on). When this message is displayed, push in (switch on) the extended storage fuse switch to turn off the message. For more information, see “Extended storage fuse switch” .
Meters and gauges
1. Tachometer
2. Engine coolant temperature gauge
3. Vehicle information display
— Odometer/twin trip odometer
— Trip computer
— Torque vectoring AWD (AWD model)
— Outside air temperat ...
Tachometer
The tachometer indicates engine speed in revolutions per minute (RPM). Do not
rev the engine into the red zone1 .
CAUTION
When engine speed approaches the red zone, shift to a higher gear or red ...
Other materials:
Liquid Gasket
REMOVAL OF LIQUID GASKET SEALING
• After removing mounting nuts and bolts, separate the mating surface
using the seal cutter [SST: KV10111100] (A) and remove old
liquid gasket sealing.
CAUTION:
Be careful not to damage the mating surfaces.
• Tap the seal cutter [SST: KV10111100] to inser ...
B210C starter control relay
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210C is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
PCS-30, "DTC Logic".
• When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1
second), the DTC B210C may be
detected.
...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW FOR MALFUNCTION
Interview the symptom to the customer.
>> GO TO 2.
2.SYMPTOM CHECK
Check the symptom from the customer's information.
>> GO TO 3.
3.BASIC INSPECTION
Check the operation o ...
