Nissan Juke Owners Manual : Towing your vehicle

When towing your vehicle, all State (Provincial in Canada) and local regulations for towing must be followed. Incorrect towing equipment could damage your vehicle. Towing instructions are available from a NISSAN dealer. Local service operators are familiar with the applicable laws and procedures for towing. To assure proper towing and to prevent accidental damage to your vehicle, NISSAN recommends that you have a service operator tow your vehicle. It is advisable to have the service operator carefully read the following precautions.

WARNING

• Never ride in a vehicle that is being towed.

• Never get under your vehicle after it has been lifted by a tow truck.

CAUTION

• When towing, make sure that the transmission, axles, steering system and powertrain are in working condition.

If any unit is damaged, dollies must be used.

• Always attach safety chains before towing.

For information about towing your vehicle behind a recreational vehicle (RV), see “Flat towing”  of this manual.

If your vehicle overheats
CAUTION • Do not continue to drive if your vehicle overheats. Doing so could cause engine damage or a vehicle fire. • To avoid the danger of being scalded, never remove the radiator cap while ...

Towing recommended by NISSAN
Two-Wheel Drive (2WD) models NISSAN recommends that your vehicle be towed with the driving (front) wheels off the ground or place the vehicle on a flat bed truck as illustrated. CAUTION •&nbs ...

Other materials:

The light reminder warning does not sound
Description Light reminder warning chime does not sound even though headlamp is illuminated. Diagnosis Procedure 1.CHECK COMBINATION SWITCH (LIGHTING SWITCH) OPERATION Check that the headlamps operate normally by operating the combination switch (lighting switch). Do they operate normally ...

Thermo control amplifier
Removal and Installation REMOVAL 1. Remove evaporator. Refer to HA-115, "EVAPORATOR : Removal and Installation". 2. Remove thermo control amp. from evaporator. INSTALLATION Note the following items, and then install in the reverse order of removal. CAUTION: • Replace O-ring ...

P0444 EVAP canister purge volume control solenoid valve
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ...