Engine block heater (if so equipped)

Engine block heaters are used to assist in cold temperature starting. The engine block heater should be used when the outside temperature is 208F (−78C) or lower. To use the engine block hea ...

Hazard warning flasher switch

Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights will flash. WARNING •  If stopping for an emergency, be sure to mov ...

Other materials:

For frontal collision : When SRS is activated in a collision
CAUTION: Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles. WORK PROCEDURE 1. Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed. 2. Replace the diagnosis sensor unit. ...

Intake sensor
Exploded View Refer to HA-43, "Exploded View (Automatic Air Conditioning)". (HR16DE) Refer to HA-97, "Exploded View (Automatic Air Conditioning)". (MR16DDT) Removal and Installation REMOVAL 1. Remove evaporator. • Refer to HA-55, "EVAPORATOR : Removal and Installat ...

P0605 ECM
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...