Trip computer

The switch for the trip computer is located on the meter panel. When the ignition switch is placed in the ON position, modes of the trip computer can be selected by pushing the trip computer mode ...

Checking bulbs

With all doors closed, apply the parking brake and place the ignition switch in the ON position without starting the engine. The following lights will come on: , or , , , , , The followin ...

Other materials:

Air breather hose
Removal and Installation REMOVAL 1. Remove clip from bracket. 2. Remove air breather hose from transaxle assembly. INSTALLATION Note the following, and install in the reverse order of removal. CAUTION: • Check that air breather hose is not collapsed or blocked due to folding or bending ...

Periodic maintenance
ROAD WHEEL Adjustment BALANCING WHEELS (ALUMINUM WHEEL) Preparation Before Adjustment Using releasing agent, remove double-faced adhesive tape from the road wheel. CAUTION: • Be careful not to scratch the road wheel during removal. • After removing double-faced adhesive tape, wipe clean tra ...

Drive belt
Checking • Inspection should be done only when engine is cold or over 30 minutes after the engine is stopped. 1 : Alternator 2 : Water pump 3 : Crankshaft pulley 4 : A/C compressor 5 : Idler pulley 6 : Drive belt • Visually check belts for wear, damage, and cracks on inside and edges. ...