Nissan Juke Service and Repair Manual : EPS warning lamp does not turn off

Description

EPS warning lamp does not turn OFF several seconds after engine started.

Diagnosis Procedure

1.PERFORM SELF-DIAGNOSIS

1. Turn the ignition switch OFF to ON.With CONSULT-III


1. Turn the ignition switch OFF to ON.

2. Perform “EPS” self-diagnosis.

Is any DTC detected? YES >> Check the DTC. Refer to STC-14, "DTC Index".

NO >> GO TO 2.

2.CHECK EPS WARNING LAMP

Perform the trouble diagnosis of EPS warning lamp. Refer to STC-26, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the specific malfunctioning part.

3.CHECK EPS CONTROL UNIT POWER SUPPLY AND GROUND CIRCUIT

Perform the trouble diagnosis of EPS control unit power supply and ground. Refer to STC-19, "Diagnosis Procedure".

Is the inspection result normal? YES >> Check that there is no malfunction in each harness connector pin terminal or disconnection.

NO >> Repair or replace the specific malfunctioning part.

    EPS warning lamp does not turn on
    Description EPS warning lamp does not turn ON when turning ignition switch ON from OFF. (Check the illumination of the EPS warning lamp.) Diagnosis Procedure 1.CHECK EPS WARNING LAMP Perform th ...

    Steering wheel turning force is heavy or light
    Description Steering wheel turning force is heavy or light. Diagnosis Procedure 1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP Check that the EPS warning lamp turns ON when ignition switch turns ...

    Other materials:

    Repairing material
    Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators. URETHANE FOAM APPLICATIONS Use commercially available Urethane foam for sealant ...

    5TH main gear assembly
    Removal and Installation REMOVAL 1. Shift the shifter lever to the 3rd gear position. 2. Disconnect the shifter cable and the selector cable from shifter lever A and selector lever. Refer to TM-25, "Removal and Installation". CAUTION: Never move shifter lever A and the selector l ...

    Lower link
    Exploded View 1. Rear suspension member 2. Adjusting bolt 3. Upper link 4. Eccentric disk 5. Lower link 6. Suspension arm bracket 7. Suspension arm : Vehicle front : Always replace after every disassembly. : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Remove tires. Re ...