Nissan Juke Service and Repair Manual : EPS warning lamp does not turn on

Description

EPS warning lamp does not turn ON when turning ignition switch ON from OFF. (Check the illumination of the EPS warning lamp.)

Diagnosis Procedure

1.CHECK EPS WARNING LAMP

Perform the trouble diagnosis of EPS warning lamp. Refer to STC-26, "Diagnosis Procedure".

Is the inspection result normal? YES >> Check that there is no malfunction in each harness connector pin terminal or disconnection.

NO >> Repair or replace the specific malfunctioning part.

    EPS warning lamp does not turn off
    Description EPS warning lamp does not turn OFF several seconds after engine started. Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS With CONSULT-III 1. Turn the ignition switch OFF to ON. 2. Perfo ...

    Other materials:

    B2268 water temp
    Description The engine coolant temperature signal is transmitted from ECM to the combination meter via CAN communication. DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS OF ECM Perform “Self Diagnosis Result” of “ENGINE”, and repair or replace malfuncti ...

    Back door opener actuator
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “TRUNK/BACK DOOR” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES > ...

    Injection tube and fuel injector
    Exploded View 1. Spill hose 2. Injection tube 3. Fuel injector 4. Heat protection washer 5. Fuel injector bracket 6. Fuel injector bracket spacer 7. Fuel rail stud bolt 8. Fuel rail 9. High pressure protection cover (lower) 10. Injection tube 11. High pressure supply pump 12. H ...