Nissan Juke Service and Repair Manual : The parking brake release warning continues sounding, or does not sound

Nissan Juke Service and Repair Manual / Warning Chime System / Symptom diagnosis / The parking brake release warning continues sounding, or does not sound

Description

• The parking brake warning buzzer sounds continuously during vehicle travel though the parking brake is released.

• The parking brake warning buzzer does not sound at all even though driving the vehicle with the parking brake applied.

Diagnosis Procedure

1.CHECK PARKING BRAKE WARNING LAMP

1. Start the engine.

2. Check the operation of the brake warning lamp by operating the parking brake.

When parking brake is applied : ON When parking brake is released : OFF

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation" NO >> GO TO 2.

2.CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT

Perform check for the parking brake switch signal circuit. Refer to WCS-41, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair harness or connector.

3.CHECK PARKING BRAKE SWITCH

Perform a unit check for the parking brake switch. Refer to WCS-41, "Component Inspection".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation" NO >> Replace parking brake switch. Refer to PB-4, "Exploded View".

    The light reminder warning does not sound
    Description Light reminder warning chime does not sound even though headlamp is illuminated. Diagnosis Procedure 1.CHECK COMBINATION SWITCH (LIGHTING SWITCH) OPERATION Check that the headlamps o ...

    Other materials:

    Antenna base
    Exploded View 1. Antenna rod 2. Antenna base : N·m (kg-m, in-lb) Removal and Installation REMOVAL 1. Remove headlining. Refer to INT-26, "Exploded View". 2. Disconnect antenna feeder connector. 3. Remove nut to remove antenna base. INSTALLATION Install in the reverse order ...

    Replacement operations
    Description • This section is prepared for technicians who have attained a high level of skill and experience in repairing collision-damaged vehicles and also use modern service tools and equipment. Persons unfamiliar with body repair techniques should not attempt to repair collision-damage ...

    Line pressure test
    Work Procedure INSPECTION 1. Check the engine oil level. Replenish if necessary. LU-25, "Inspection". 2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection". 3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (12 ...