Removal and installation

COMBINATION METER Exploded View REMOVAL Refer to IP-12, "Exploded View". DISASSEMBLY 1. Front cover 2. Unified meter control unit Removal and Installation REMOVAL 1. Remove clu ...

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...

Other materials:

Keyfob battery
Exploded View 1. Upper case 2. Key 3. Switch cover 4. Switch rubber 5. Board surface 6. Battery 7. plate 8. Lower case 9. Screw Removal and Installation REMOVAL 1. Remove screw (9) on the rear of keyfob. 2. Place the key with the lower case (8) facing up. Set a screw-driver wrap ...

B26FA cranking request circuit
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26FA is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26FA is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, &qu ...

PTC heater
Component Function Check 1.CHECK PTC HEATER OPERATION 1. Start the engine. 2. Operate fan control dial. 3. Operate temperature control dial to full hot position. 4. Check for warm air at discharge air outlet. NOTE: • Engine must be cold. • Battery must be charged. Is the inspection ...