Basic inspection

DIAGNOSIS AND REPAIR WORKFLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions ...

Power supply and ground circuit

Combination meter COMBINATION METER : Diagnosis Procedure 1.CHECK FUSE Check for blown fuses. Is the inspection result normal? YES >> GO TO 2. NO >> Be sure to eliminate cause of ...

Other materials:

B1113, B1114 satellite sensor RH
DTC Logic DTC DETECTION LOGIC 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp status. Refer to SRC-12, ...

Diagnosis system (BCM) (with intelligent key system)
Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the fo ...

Evaporative emission system
Inspection 1. Visually inspect EVAP vapor lines for improper attachment and for cracks, damage, loose connections, chafing and deterioration. 2. Check EVAP canister as follows: a. Block port (A). Orally blow air through port (B). Check that air flows freely through port (C). b. Block port (B ...