Nissan Juke Service and Repair Manual : Meter buzzer circuit

Component Function Check

1.CHECK OPERATION OF METER BUZZER

1. Select “BUZZER” of “BCM” on CONSULT-III.

2. Perform “LIGHT WARN ALM” of “Active Test”.

Does meter buzzer beep? YES >> INSPECTION END

NO >> GO TO 2.

2.CHECK COMBINATION METER INPUT SIGNAL

Select the “Data Monitor” for the “METER/M&A” and check the “BUZZER” monitor value.

BUZZER
Under the condition of buzzer input : On Except above : Off

Is the inspection result normal? YES >> Replace combination meter.

NO >> Replace BCM. Refer to BCS-93, "Removal and Installation" (with Intelligent Key system) or BCS- 161, "Removal and Installation" (without Intelligent Key system).

Diagnosis Procedure

1.CHECK POWER SUPPLY OF COMBINATION METER

Check power supply of combination meter. Refer to WCS-39, "COMBINATION METER : Diagnosis Procedure".

Is the inspection result normal? YES >> INSPECTION END

NO >> Repair power supply circuit of combination meter.

    Power supply and ground circuit
    Combination meter COMBINATION METER : Diagnosis Procedure 1.CHECK FUSE Check for blown fuses. Is the inspection result normal? YES >> GO TO 2. NO >> Be sure to eliminate cause of ...

    Parking brake switch signal circuit
    Diagnosis Procedure 1.CHECK COMBINATION METER INPUT SIGNAL 1. Turn ignition switch ON. 2. Check the voltage between combination meter harness connector and ground. Is the inspection result norma ...

    Other materials:

    Blind Spot Warning (BSW)
    WARNING Failure to strictly adhere to the safety warnings and operational instructions for the proper use of the Blind Spot Warning (BSW) system could result in a collision, potentially causing serious injury or death. The BSW system is intended to supplement, not replace, standa ...

    Rear window defogger on signal
    With auto A/C WITH AUTO A/C : Description Turns the indicator lamp in the rear window defogger switch ON when operating the rear window defogger WITH AUTO A/C : Component Function Check 1.CHECK REAR WINDOW DEFOGGER ON SIGNAL Check that the indicator lamp of rear window defogger switch is illu ...

    Positive crankcase ventilation
    Inspection 1.CHECK PCV VALVE With engine running at idle, remove PCV valve from rocker cover. A properly working valve makes a hissing noise as air passes through it. A strong vacuum should be felt immediately when a finger is placed over valve inlet. Is the inspection result normal? YES &g ...