Nissan Juke Service and Repair Manual : Ignition position warning function does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM

Check that DTC is not detected with BCM.

Is the inspection result normal? YES >> GO TO 2.

NO >> Refer to BCS-67, "DTC Index".

2.CHECK POWER DOOR LOCK OPERATION

Check power door lock operation.

Does door lock/unlock with driver side door lock knob and door key cylinder? YES >> GO TO 3.

NO >> Refer to DLK-276, "ALL DOOR : Diagnosis Procedure".

3.CHECK DOOR SWITCH

Check door switch.

Refer to DLK-258, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK UNLOCK SENSOR

Check unlock sensor.

Refer to DLK-270, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Door does not lock/unlock with intelligent key
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND TCM Check that DTC is not detected with BCM and TCM. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "D ...

    ANTI-HIJACK function does not operate
    Diagnosis Procedure 1.CHECK “DOOR LOCK–UNLOCK SET” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT” mode. 3. Check “DO ...

    Other materials:

    Operation
    AUTOMATIC SPEED CONTROL DEVICE (ASCD) AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Switch Name and Function SWITCHES AND INDICATORS 1. CRUISE indicator 2. SET indicator 3. CANCEL switch 4. RES / + switch 5. SET / − switch 6. Speed limiter MAIN Switch 7. ASCD MAIN switch A. On the co ...

    P0420 three way catalyst function
    DTC Logic DTC DETECTION LOGIC The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2. A three way catalyst (manifold) with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen storage c ...

    Drive belt
    1. Alternator 2. Drive belt auto-tensioner 3. Crankshaft pulley 4. Air conditioner compressor 5. Water pump WARNING Be sure the ignition switch is in the OFF or LOCK position before servicing drive belts. The engine could rotate unexpectedly. 1. Visually inspect the belt for signs of unus ...