Nissan Juke Service and Repair Manual : Door & Lock type 2
- How to use this manual
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Precaution for Procedure without Cowl Top Cover
- Work
- Preparation
- System description
- Component parts
- System (power door lock system)
- System (intelligent key system)
- Back door opener system
- Diagnosis system (BCM)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- B2621 inside antenna
- B2622 inside antenna
- B2623 inside antenna
- B2626 OUTSIDE ANTENNA
- B2627 outside antenna
- B2628 outside antenna
- Back door opener actuator
- Back door opener switch
- Back door request switch
- Buzzer (combination meter)
- Door lock actuator
- Door lock and unlock switch
- Door request switch
- Door switch
- Hazard function
- Intelligent key
- Intelligent key warning buzzer
- Key warning lamp
- Remote keyless entry receiver
- Shift P warning lamp
- Unlock sensor
- Symptom diagnosis
- Door does not lock/unlock with door request switch
- Door does not lock/unlock with driver side door lock knob or door key cylinder
- Door does not lock/unlock with door lock and unlock switch
- Door does not lock/unlock with intelligent key
- Ignition position warning function does not operate
- ANTI-HIJACK function does not operate
- Back door does not opened
- Auto door lock operation does not operate
- Vehicle speed sensing auto lock operation does not operate
- IGN off interlock door unlock function does not operate
- P range interlock door lock/unlock function does not operate
- Hazard and buzzer reminder does not operate
- Key reminder function does not operate
- Off position warning does not operate
- P position warning does not operate
- ACC warning does not operate
- Take away warning does not operate
- Intelligent key low battery warning does not operate
- Door lock operation warning does not operate
- Key ID warning does not operate
- Unlock link function does not operate
- Squeak and rattle trouble diagnoses
- Removal and installation
Intelligent key battery
Removal and Installation
1. Release the lock knob at the back of the Intelligent Key and remove the
mechanical key.
2. Insert a flat-blade screwdriver (A) wrapped with a cloth into the
slit of th ...
How to use this manual
APPLICATION NOTICE
Information
Check the vehicle type to use the service information in this section.
...
Other materials:
Brake pedal position switch
Component Function Check
1.CHECK BRAKE PEDAL POSITION SWITCH FUNCTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select “BRAKE SW1” in “DATA MONITOR” mode of “ENGINE” using CONSULT-III.
3. Check “BRAKE SW1” indication as per the following conditions.
Without CONSULT-III
1. Turn ignitio ...
B1050, B1055 driver air bag module
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
applications. It is an on-board multiplex
communication line with high data communication speed and excellent error
detection ability. A modern
vehicle is equipped with many ECMs, and each control unit shar ...
