Nissan Juke Service and Repair Manual : Key warning lamp

Component Function Check

1.CHECK FUNCTION

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.

2. Select “INDICATOR” in “ACTIVE TEST” mode.

3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?


Is the inspection result normal? YES >> Key warning lamp is OK.

NO >> Refer to DLK-265, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK KEY WARNING LAMP

Refer to MWI-22, "On Board Diagnosis Function".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> INSPECTION END

    Intelligent key warning buzzer
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “OUTSIDE BUZZER” in “ACTIVE TEST” mode. 3. Check that the function opera ...

    Remote keyless entry receiver
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “RKE OPE COUN1” in “DATA MONITOR” mode. 3. Check that the function opera ...

    Other materials:

    Insufficient cooling
    Description Symptom • Insufficient cooling • No cool air comes out. (Air flow volume is normal.) Diagnosis Procedur NOTE: Perform self-diagnosis with CONSULT-III before performing symptom diagnosis. If any malfunction result or DTC is detected, perform the corresponding diagnosis. 1. ...

    BCM branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? YES &g ...

    Rear wiper auto stop signal circuit
    Component Function Check 1.CHECK REAR WIPER (AUTO STOP) OPERATION CONSULT-III DATA MONITOR 1. Select “WIPER” of BCM data monitor item. 2. Operate the rear wiper. 3. Check that “RR WIPER STOP” changes to “On” and “Off” linked with the wiper operation. Is the status of item n ...