Nissan Juke Service and Repair Manual : DTC/circuit diagnosis

Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM 1. Get detailed information from the customer about the symptom (the condition and the en ...

B2621 inside antenna
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Select “INTELLIGENT KEY� of “BCM� using CONSULT-III. 2. Select “INSIDE ANT DIAGNOSIS†...

Other materials:

Assembly and Installation
• Use torque wrench to tighten bolts or nuts to specification. • When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, ...

Position switch
Removal and Installation REMOVAL 1. Remove air cleaner case. (K9K) Refer to EM-280, "Removal and Installation". 2. Remove battery. (MR16DDT) Refer to PG-124, "Removal and Installation". 3. Disconnect position switch connector. 4. Remove position switch from transaxle case. ...

Parking brake switch
Component Function Check 1.CHECK PARKING BRAKE SWITCH OPERATION Operate the parking brake lever. Then check that the brake warning lamp in the combination meter turns ON/ OFF correctly. Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to BRC-70, "Diagno ...