Nissan Juke Service and Repair Manual : Shift P warning lamp

Component Function Check

1.CHECK FUNCTION

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.

2. Select “LCD” in “ACTIVE TEST” mode.

3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?


Is the inspection result normal? YES >> Shift P warning lamp is OK.

NO >> Refer to DLK-269, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK SHIFT P WARNING LAMP

Refer to MWI-22, "On Board Diagnosis Function".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> INSPECTION END

    Remote keyless entry receiver
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “RKE OPE COUN1” in “DATA MONITOR” mode. 3. Check that the function opera ...

    Unlock sensor
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “UNLK SEN -DR” in “DATA MONITOR” mode. 3. Check that the function operat ...

    Other materials:

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each co ...

    P1805 brake switch
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Fully depress the brake pedal for at least 5 seconds. 3. Erase DTC. 4. Check 1st trip DTC. Is 1st trip DTC detected? YES >> Go to EC-734, "Diagnosis Pr ...

    B2196 dongle unit
    Description BCM performs ID verification between BCM and dongle unit. When verification result is OK, BCM permits cranking. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Turn ignition switch OFF. 3. Turn igni ...