Nissan Juke Service and Repair Manual : Hazard function

Component Function Check

1.CHECK FUNCTION

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.

2. Select “FLASHER” in “ACTIVE TEST” mode.

3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?


Is the inspection result normal? YES >> Hazard warning lamp circuit is OK.

NO >> Refer to DLK-261, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK HAZARD SWITCH CIRCUIT

Refer to EXL-72, "Component Function Check".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> INSPECTION END

    Door switch
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR SW-DR”, “DOOR SW-AS”, “DOOR SW-RL”, “DOOR SW-RR”, “DOOR SW-BK ...

    Intelligent key
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “RKE OPE COUN1” in “DATA MONITOR” mode. 3. Check that the function opera ...

    Other materials:

    Outside key antenna
    Driver side DRIVER SIDE : Removal and Installation REMOVAL Remove the driver side outside handle. Refer to DLK-176, "OUTSIDE HANDLE : Removal and Installation". INSTALLATION Install in the reverse order of removal. Passenger side PASSENGER SIDE : Removal and Installation REMOVA ...

    Towing your vehicle
    When the need arises to tow your Nissan Leaf, you must ensure that all relevant state, provincial, and local regulations concerning vehicle transport are strictly observed. Utilizing incorrect towing equipment or improper techniques can lead to significant mechanical damage to your vehicle, so it is ...

    B210B starter control relay
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC B210B is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS- 30, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press push-button ignition switch under the followin ...