Nissan Juke Service and Repair Manual : The braking distance is long

Description

Brake stopping distance is long when ABS function is operated.

Diagnosis Procedure

CAUTION:
Brake stopping distance on slippery road like rough road, gravel road or snowy road may become longer when ABS is operated than when ABS is not operated

.

1.CHECK BRAKING FORCE

Check brake force using a brake tester.

Is the inspection result normal? YES >> GO TO 2.

NO >> Check each components of brake system.

2.CHECK BRAKE PERFORMANCE

Disconnect ABS actuator and electric unit (control unit) connector so that ABS does not operate. Check brake stopping distance in this condition. Connect harness connectors after checking.

Is the inspection result normal? YES >> Normal

NO >> Check each components of brake system.

    Unexpected brake pedal reaction
    Description A malfunction of brake pedal feel (height or others) is detected when brake pedal is depressed. Diagnosis Procedure 1.CHECK FRONT AND REAR AXLE Check that there is no excessive loose ...

    Does not operate
    Description ABS function and EBD function does not operate. Diagnosis Procedure CAUTION: ABS function and EBD function never operate when the vehicle speed is 10 km/h (6.2 MPH) or less. 1.CHE ...

    Other materials:

    B1138, B1139, B1140, B1141, B1142, B1143 diagnosis sensor unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

    Operation inspection
    Work Procedure The purpose of the operational check is to check that the individual system operates normally. Check condition : Engine running at normal operating temperature. 1.CHECK MEMORY FUNCTION 1. Set temperature to 30°C by operating the temperature control dial. 2. Press OFF switch. 3 ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...