Nissan Juke Service and Repair Manual : Auto door lock operation does not operate

Nissan Juke Service and Repair Manual / Door & Lock type 3 / Symptom diagnosis / Auto door lock operation does not operate

Diagnosis Procedure

1.CHECK “AUTO LOCK SET” SETTING WITH CONSULT-III

1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III.

2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode.

3. Check “AUTO LOCK SET” in “WORK SUPPORT”.

Refer to DLK-372, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT) (With Super Lock)".

Is the inspection result normal? YES >> GO TO 2.

NO >> Set “AUTO LOCK SET” in “WORK SUPPORT”.

2.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    P range interlock door lock/unlock function does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” i ...

    Door lock status indicator does not illuminate
    Diagnosis Procedure 1.CHECK DOOR LOCK STATUS INDICATOR Check door lock status indicator. Refer to DLK-395, "Component Function Check". Is the inspection result normal? YES >> ...

    Other materials:

    P0097, P0098 IAT sensor 2
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

    System Temporarily Unavailable
    The ICC system may enter a state of temporary unavailability under the following conditions: In these specific scenarios, the ICC system may not cancel automatically, yet it might fail to maintain the previously selected following distance from the lead vehicle. System Te ...

    P1205 exhaust fuel injector
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK EXHAUST FUEL INJECTOR POWER SUPPLY CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect exhaust fuel injector harness connector. 3. Turn ignition switch ON. 4. Check the voltage between exhaust fuel injector harness ...