Unlock sensor

Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “LOCK STATUS” in “DATA MONITOR” mode. 3. Check that the function operates normally according t ...

Door does not lock/unlock with door key cylinder operation

Diagnosis Procedure 1.CHECK POWER DOOR LOCK OPERATION Check power door lock operation. Does door lock/unlock with door lock and unlock switch? YES >> GO TO 2. NO >> Go to DLK-415, ...

Other materials:

Door mirror remote control switch
Exploded View 1. Instrument lower panel 2. Switch bracket 3. Door mirror remote control switch Removal and Installation REMOVAL 1. Remove the instrument lower panel. Refer to IP-13, "Removal and Installation". 2. Remove mounting screws and remove switch bracket from instrument ...

P0713 transmission fluid temperature sensor A
DTC Logic DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE 1. Start the ...

B1202, B1203, B1204, B1205, B1206, B1207 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...