Nissan Juke Service and Repair Manual : Door does not lock/unlock with keyfob

Diagnosis Procedure

1.CHECK POWER DOOR LOCK OPERATION

Check power door lock operation.

Does door lock/unlock with door lock and unlock switch? YES >> GO TO 2.

NO >> Go to DLK-415, "ALL DOOR : Diagnosis Procedure".

2.CHECK REMOTE KEYLESS ENTRY RECEIVER

Check remote keyless entry receiver.

Refer to DLK-404, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CHECK KEYFOB BATTERY

Check keyfob battery.

Refer to DLK-403, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Door does not lock/unlock with door lock and unlock switch
    All door ALL DOOR : Description All doors do not lock/unlock using door lock and unlock switch. ALL DOOR : Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switc ...

    Door lock status indicator does not illuminate
    Diagnosis Procedure 1.CHECK DOOR LOCK STATUS INDICATOR Check door lock status indicator. Refer to DLK-395, "Component Function Check". Is the inspection result normal? YES >> ...

    Other materials:

    P0102, P0103 MAF sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

    P0530 refrigerant pressure sensor
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or ...

    Service Notice or Precautions for Manual Transaxle
    CAUTION: • Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the original position every time when removing transaxle assembly. At this timing, dust on the sliding parts may damage a seal of CSC and may cause clutch fluid leakage. Refer to CL-27, "Removal and In ...