Nissan Juke Service and Repair Manual : Key out interlock door unlock function does not operate

Nissan Juke Service and Repair Manual / Door & Lock type 3 / Symptom diagnosis / Key out interlock door unlock function does not operate

Diagnosis Procedure

1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT”

1. Select “DOOR LOCK” of “BCM” using CONSULT-III.

2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode.

3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”.

Refer to DLK-371, "DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK) (With Super Lock)".

Is the inspection result normal? YES >> GO TO 2.

NO >> Set “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”.

2.CHECK “AUTOMATIC DOOR UNLOCK SELECT” SETTING IN “WORK SUPPORT”

1. Select “DOOR LOCK” of “BCM” using CONSULT-III.

2. Select “AUTOMATIC DOOR UNLOCK SELECT” in “WORK SUPPORT” mode.

3. Check “AUTOMATIC DOOR UNLOCK SELECT” in “WORK SUPPORT”.

Refer to DLK-371, "DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK) (With Super Lock)".

Is the inspection result normal? YES >> GO TO 3.

NO >> Set “AUTOMATIC DOOR UNLOCK SELECT” in “WORK SUPPORT”.

3.CHECK KEY SWITCH

Check key switch. Refer to DLK-401, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident

    Unlock link function does not operate
    Diagnosis Procedure 1.REPLACE BCM 1. Replace BCM. Refer to BCS-161, "Removal and Installation". 2. Confirm the operation after replacement. Is the result normal? YES >> INSPECTI ...

    Key reminder function does not operate
    Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switch. Refer to the following. • Driver side: Refer to DLK-391, "DRIVER SIDE : Component Function Check& ...

    Other materials:

    Engine protection control at low engine oil pressure
    Engine protection control at low engine oil pressure : System Diagram Engine protection control at low engine oil pressure : System Description INPUT/OUTPUT SIGNAL CHART SYSTEM DESCRIPTION • The engine protection control at low engine oil pressure warns the driver of a decrease in engin ...

    Steering wheel switch for audio control
    1. SOURCE select switch 2. Tuning switch 3. VOLUME control switch The audio system can be operated using the controls on the steering wheel. SOURCE select switch Push the SOURCE select switch to change the mode to available audio source. VOLUME control switch Push up or down the VOLUME cont ...

    C1144 incomplete steering angle sensor adjustment
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CON ...