Nissan Juke Service and Repair Manual : Hazard reminder operation does not operate

Nissan Juke Service and Repair Manual / Door & Lock type 3 / Symptom diagnosis / Hazard reminder operation does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM AND COMBINATION METER

Check that DTC is not detected with BCM and combination meter.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Refer to BCS-141, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index". (Combination meter)

2.CHECK “HAZARD LAMP SET” SETTING IN “WORK SUPPORT”

1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III.

2. Select “HAZARD LAMP SET” in “WORK SUPPORT” mode.

3. Check “HAZARD LAMP SET” in “WORK SUPPORT”.

Refer to DLK-372, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT) (With Super Lock)".

Is the inspection result normal? YES >> GO TO 3.

NO >> Set “HAZARD LAMP SET” in “WORK SUPPORT”.

3.CHECK HAZARD WARNING LAMP

Check hazard warning lamp.

Refer to DLK-400, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Key reminder function does not operate
    Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switch. Refer to the following. • Driver side: Refer to DLK-391, "DRIVER SIDE : Component Function Check& ...

    Squeak and rattle trouble diagnoses
    Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the ...

    Other materials:

    P0847 transmission fluid pressure SEN/SW B
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION With ...

    Basic inspection
    DIAGNOSIS AND REPAIR WORK FLOW Work Flow DESCRIPTION OF TROUBLE DIAGNOSIS FLOWCHART DETAILS OF TROUBLE DIAGNOSIS FLOWCHART 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction oc ...

    System
    Warning chime system WARNING CHIME SYSTEM : System Diagram WARNING CHIME SYSTEM : System Description COMBINATION METER The combination meter sounds the alarm buzzer installed in the combination meter when receiving the buzzer output signal transmitted from each unit. BCM BCM receives si ...