Nissan Juke Service and Repair Manual : Brake Control System without ESP
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Precaution for Procedure without Cowl Top Cover
- Precaution for Brake System
- Precaution for Brake Control system
- System description
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- C1101, C1102, C1103, C1104 WHEEL SENSOR
- C1105, C1106, C1107, C1108 wheel sensor
- C1109 power and ground system
- C1110 ABS actuator and electric unit (control unit)
- C1111 ABS motor, motor relay system
- C1115 wheel sensor
- C1120, C1122, C1124, C1126 ABS in valve system
- C1121, C1123, C1125, C1127 ABS out valve system
- C1140 actuator relay system
- U1000 can comm circuit
- U1010 control unit (can)
- Power supply and ground circuit
- Stop lamp switch
- Parking brake switch
- Brake fluid level switch
- ABS warning lamp
- Brake warning lamp
- Symptom diagnosis
- Excessive operation frequency
- Unexpected brake pedal reaction
- The braking distance is long
- Does not operate
- Brake pedal vibration or operation sound occurs
- Vehicle jerks during
- Normal operating condition
- Removal and installation
Service data and specifications (SDS)
Parking Drum Brake
Parking Brake Control
...
Precaution
...
Other materials:
Center stem assembly
Exploded View
1. Filler plug
2. Gasket
3. Drain plug
4. Breather tube
5. Clip
6. Breather hose
7. Breather
8. sub-harness clip
9. sub-harness
10. Rear cover
11. Center stem
12. Side bearing (right)
13. Side bearing adjusting shim (right)
14. Side oil seal (right)
15. Connec ...
B1074, B1075, B1076, B1077, B1078, B1079 diagnosis sensor unit
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
B260C steering lock unit
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Shift selector lever to the P position.
2. Press push-button ignition switch under the following condition.
- Brake pedal: Not depressed
3. Turn ignition switch ON.
4. Turn ignition switch OFF. ...
