Nissan Juke Service and Repair Manual : Excessive operation frequency

Description

ABS function and EBD function operates in excessive operation frequency.

Diagnosis Procedure

1.CHECK BRAKING FORCE

Check brake force using a brake tester.

Is the inspection result normal? YES >> GO TO 2.

NO >> Check brake system.

2.CHECK FRONT AND REAR AXLE

Check that there is no excessive looseness in front and rear axle.

• Front axle: Refer to FAX-41, "Inspection".

• Rear axle: Refer to RAX-4, "Inspection" Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace error-detected parts.

3.CHECK WHEEL SENSOR

Check wheel sensor.

• Check installation and damage of wheel sensor.

• Check connection of wheel sensor harness connector.

• Check terminal of wheel sensor harness connector.

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace wheel sensor.

• Front wheel sensor: Refer to BRC-84, "FRONT WHEEL SENSOR : Removal and Installation".

• Rear wheel sensor: Refer to BRC-86, "REAR WHEEL SENSOR : Removal and Installation".

4.CHECK SENSOR ROTOR

Check that there is no looseness, damage or foreign material on sensor rotor.

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair installation or replace sensor rotor.

• Front sensor rotor: Refer to BRC-88, "FRONT SENSOR ROTOR : Removal and Installation".

• Rear sensor rotor. Refer to BRC-86, "REAR WHEEL SENSOR : Removal and Installation".

5.CHECK WARNING LAMP TURNS OFF

Check that ABS warning lamp and brake warning lamp turn OFF approx. 1 second after key switch is turned ON and stay in OFF status during driving.

CAUTION:
Brake warning lamp turns ON when parking brake is operated (parking brake switch is ON) or brake fluid is less than the specified level (brake fluid level switch is ON).

Is the inspection result normal? YES >> Normal NO >> Perform self-diagnosis for “ABS” with CONSULT-III.

    Unexpected brake pedal reaction
    Description A malfunction of brake pedal feel (height or others) is detected when brake pedal is depressed. Diagnosis Procedure 1.CHECK FRONT AND REAR AXLE Check that there is no excessive loose ...

    Other materials:

    Front wiper blade
    Exploded View 1. Wiper blade 2. Wiper arm Removal and Installation REMOVAL Push up the lever (A) of wiper blade (1), while sliding wiper blade toward the direction of the arrow to remove it from wiper arm (2). CAUTION: Be careful not to drop the wiper blade onto the windshield glass. ...

    Crash zone sensor
    Exploded View 1. Crash zone sensor 2. Bracket : Vehicle front : Do not reuse N·m (kg-m, ft-lb) Removal and Installation WARNING: • Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more. • Never use the air tools or electric tools f ...

    CVT fluid
    Inspection CHECKING CVT FLUID The fluid level should be checked with the fluid warmed up to 50 to 80°C (122 to 176°F). The fluid level check procedure is as follows: 1. Check for fluid leakage. 2. With the engine warmed up, drive the vehicle in an urban area. When ambient temperature is 20 ...