Nissan Juke Service and Repair Manual : Does not operate

Description

ABS function and EBD function does not operate.

Diagnosis Procedure

CAUTION:
ABS function and EBD function never operate when the vehicle speed is 10 km/h (6.2 MPH) or les

s.

1.CHECK ABS WARNING LAMP

Check that ABS warning lamp and brake warning lamp turn ON and turn OFF approx. 1 second after key switch is turned ON. Check that ABS warning lamp and brake warning lamp and stay in OFF status during driving.

CAUTION:
Brake warning lamp turns ON when parking brake is operated (parking brake switch is ON) or brake fluid is less than the specified level (brake fluid level switch is ON).

Is the inspection result normal? YES >> Normal

NO >> Perform self-diagnosis for “ABS” with CONSULT-III.

    The braking distance is long
    Description Brake stopping distance is long when ABS function is operated. Diagnosis Procedure CAUTION: Brake stopping distance on slippery road like rough road, gravel road or snowy road may be ...

    Brake pedal vibration or operation sound occurs
    Description • Brake pedal vibrates and motor sound from ABS actuator and electric unit (control unit) occurs, when the engine starts. • Brake pedal vibrates during braking. CAUTION: Vibra ...

    Other materials:

    How to use brightness control and display ON/OFF button
    To change the display brightness, push the button. Pushing the button again will change the display to the day or the night display. If no operation is performed within 5 seconds, the display will return to the previous display. Push and hold the button for more than two seconds to turn t ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

    P060A ECM
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON and perform the self-diagnosis. Is the DTC P060A displayed again? YES >> GO TO 2. NO &g ...