Nissan Juke Service and Repair Manual : Parking brake switch

Component Function Check

1.CHECK PARKING BRAKE SWITCH OPERATION

Operate the parking brake lever. Then check that the brake warning lamp in the combination meter turns ON/ OFF correctly.

Is the inspection result normal? YES >> INSPECTION END

NO >> Proceed to BRC-70, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK PARKING BRAKE SWITCH CIRCUIT

1. Turn the ignition switch OFF.

2. Disconnect parking brake switch harness connector.

3. Disconnect combination meter harness connector.

4. Check continuity between parking brake switch harness connector and combination meter harness connector.

5. Check continuity between parking brake switch harness connector and


5. Check continuity between parking brake switch harness connector and ground.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace error-detected parts.

2.CHECK PARKING BRAKE SWITCH

Check the parking brake switch. Refer to BRC-70, "Component Inspection".

Is the inspection result normal? YES >> GO TO 3.

NO >> Replace parking brake switch. Refer to PB-5, "Removal and Installation".

3.CHECK COMBINATION METER

Check combination meter. Refer to MWI-23, "CONSULT-III Function".

Is the inspection result normal? YES >> Check each pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace error-detected parts.

NO >> Repair or replace combination meter. Refer to MWI-69, "Removal and Installation".

Component Inspection

1.CHECK PARKING BRAKE SWITCH

1. Turn the ignition switch OFF.

2. Disconnect parking brake switch harness connector.

3. Check continuity between parking brake switch harness connector.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> Replace parking brake switch. Refer to PB-5, "Removal and Installation".

    Stop lamp switch
    Component Function Check 1.CHECK STOP LAMP SWITCH OPERATION Depress brake pedal and check that stop lamp turns ON, or release brake pedal and check stop lamp turns OFF. Is the inspection resul ...

    Brake fluid level switch
    Component Function Check 1.CHECK BRAKE FLUID LEVEL SWITCH OPERATION When the brake fluid is full or empty. Then check that the brake warning lamp in the combination meter turns ON/OFF correctly. ...

    Other materials:

    U0101 Can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each c ...

    Electrical load signal
    Description The electrical load signal (Headlamp switch signal, rear window defogger switch signal, etc.) is transferred to ECM through the CAN communication line. Component Function Check 1.CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION 1. Turn ignition switch ON. 2. Select “DATA MONITOR” m ...

    Fuel tank
    2WD : Exploded View 1. Fuel filler cap 2. Grommet 3. Fuel filler tube 4. EVAP canister hose 5. Fuel tank mounting band (RH) 6. Fuel tank mounting band (LH) 7. Fuel tank 8. Clamp 9. Fuel filler hose 10. Vent hose Vehicle front : N?·m (kg-m, ft-lb) 2WD : Removal and Installation ...